HESC-T-026 is a photoelectric isolated converter. It complies with RS-232C, RS-422, and RS-485 standards. It converts single side RS-232 signal to a balanced differential RS-422 or RS-485 signal. The built-in photoelectric isolator can provide as high as 2,500 Vrms isolated voltage. The fast transient voltage suppression is designed to protect RS-485/422 interface. The device adopts advanced TVS (TRANSIENT VOLTAGE SUPPRESSOR). Normally, TVS tube is in high impedance state. When both sides of TVS tube suffer from high power impact in a sudden, the voltage suppression will fastly lower the impedance from both sides, and soak in large current, therefore the voltage on both sides are fixed at pre-determined value and protects the component of circuit from damage. This voltage suppression provides 1,500W for each wire with lightning and surge protection, and surge voltage and instant over-voltage protection on circuit which is caused by all reasons. The tiny inter-electrode capacitance ensures high speed transmission for RS-485/422 port. RS-232 port uses a DB9 female connector as input and RS-485/422 port uses a DB9 male connector as output.
This converter has built-in zero delay auto receiving and transmitting conversion and unique I/O circuit auto control data flow direction without any handshake signal (RTS, DTR). There is no need for jumper setting. The device is plug & play. It is compatible with current communication software and hardware, no need to set the previous working mode which is based on RS-232.
HESC-T-026 photoelectric isolated converter provides connection for point-to-point, point-to-multipoint communication. For point-to-multipoint mode, each converter supports to connect 128 RS-422 or RS-485 devices with baud rate 300 bps -115.2 Kbps. The power and data flow indicators indicate the working status.